What size mini split does a 800 sq ft living room in Lubbock, TX need?
800 ft² living room in Lubbock, TX
24,000BTU/hr
21,543 BTU/hr of load at 24.5 BTU/ft² — the figure for 2,190 cooling degree days
| Head size to buy | 24,000BTU/hr |
|---|---|
| Calculated load800 ft² × 24.5 BTU/ft² × 1.1 for a living room | 21,543BTU/hr |
| BTU per square foot hereinterpolated from Lubbock's 2,190 cooling degree days | 24.5BTU/ft² |
| What the 20 BTU/ft² rule givesthis room needs 22% more than the rule says | 17,600BTU/hr |
| Summer design temperature | 101°F |
| Winter design temperaturea mini split heats too — this is the number that decides whether it can carry the room alone | 14°F |
| Summer day–night swinga dry climate | 25°F |
| Days at or above 90°F | 94days/yr |
| Oversize from the size stepwithin the normal step | 11% |
Notes
- The "20 BTU per square foot" rule is a Midwest number. Lubbock runs 2,190 cooling degree days, which works out to 24.5 BTU/ft² — so for this living room the rule is 22% short. A single national figure has to be wrong somewhere, and this is where.
- Living room: more people, more glazing, more electronics. The 1.1× factor accounts for that.
- 24,000 BTU/hr sits close to the load, which is where a mini split works best. Inverter equipment is happiest running long and slow at part load; it is the short, hard cycles of an oversized head that leave a room cold and damp.
- Lubbock is dry — nights fall 25°F below the afternoon high, which only happens when there is little water in the air. Latent load is small, so nearly all of the head's capacity goes into temperature. A slightly undersized head is forgiving here: it simply runs longer.
- Do not forget the winter side. Lubbock designs to 14°F. A cold-climate rated head will hold most of its capacity there, but a standard one will not — ask for the capacity at 14°F in writing.
- Where these numbers come from. Lubbock International Airport, 11 km from downtown Lubbock, daily records 2015–2024. Design temperatures are calibrated against published ASHRAE values at eight airports and land within about 2°F of them.
The short answer
A 800 square foot living room in Lubbock, TX needs a head of about 24,000 BTU per hour. The calculated load is 21,543 BTU/hr.
Where that number comes from
Lubbock, TX runs 2,190 cooling degree days a year, which puts the room at 24.5 BTU per square foot rather than the 20 BTU/ft² the generic charts use. Applied to this room the rule gives 17,600 BTU/hr.
The winter half of the question
Lubbock, TX designs to 14°F. A mini split is a heat pump, and its heating capacity falls as the outdoor temperature drops — the nameplate is measured at 47°F, not at the temperature you actually need it.
Sizing a single room is not sizing a house
There is no other room to absorb a mistake. An oversized head short-cycles, never runs long enough to dehumidify, and leaves the room cold and damp.
Nearby sizes
- What size mini split does a 800 sq ft living room in Laredo, TX need?
- What size mini split does a 800 sq ft living room in Gilbert, AZ need?
- What size mini split does a 800 sq ft living room in St. Petersburg, FL need?
- What size mini split does a 800 sq ft living room in Tri-Cities, WA need?
- What size mini split does a 600 sq ft living room in Lubbock, TX need?
- What size mini split does a 800 sq ft bedroom in Lubbock, TX need?
Read more
- Mini Split Blowing Cold Air in Heat Mode — Defrost, UsuallyEvery air-source heat pump does this. Knowing what a defrost cycle looks like is the difference between waiting ten minutes and calling somebody out.
- Mini Split Leaking Water Indoors — Four Causes, One CommonA cooling head makes a couple of litres a day. It leaves through a small pipe with no pump behind it, and that pipe is where nearly every leak starts.
- Multi-Zone Mini Split Not Cooling Every Room — The Minimum Output ProblemThe system is not underpowered. It is oversized for the one room that is calling, and multi-zone units handle that far worse than single-zone ones.