What size mini split for a 700 square foot bonus room
| Head size | 24,000BTU |
|---|---|
| Calculated load700 ft² × 20 × 1.3 | 18,200BTU |
| Next size downworth considering — see the note | 18,000BTU |
| Oversize at this head | 32% |
| Room typeexposed on five sides — the hardest room in most houses | bonus room over a garage |
| Effective rate | 26BTU/ft² |
Notes
- A mini-split serves one room, so the sizing error has nowhere to go. Central air averages a mistake across the house; a head does not. Too large in a 700 ft² bonus room over a garage means short cycles, no dehumidification, and a room that reads the right temperature and feels wrong.
- 18,200 BTU falls between two heads, and the smaller one is usually the better bet. Modern inverter heads modulate down well but have a minimum output too — the 24k unit is 32% over the load and will spend the season near its floor. Unless the room has heavy west glazing or an unusual occupancy, take the 18k.
- Inverter heads are forgiving, but not infinitely. Unlike single-stage equipment they throttle down instead of cycling, which is why mini-splits tolerate imperfect sizing better than a central system. What they cannot do is run below their minimum capacity, and an oversized head sits at that floor all season — which is where the humidity complaints come from.
- The rate here is 26 BTU/ft², and that is a starting point. A room with new windows and good insulation can want 15; a bonus room over an unconditioned garage, exposed on five sides, can want 30. Ceiling height matters too — the figures assume 8 ft, and a vaulted ceiling adds proportionally.
- Heating capacity is a separate number. A head rated 12,000 BTU for cooling does not deliver 12,000 BTU of heat at 5°F outdoors — output falls sharply as it gets colder, and the derating curve is specific to the model. In a cold climate, size the head on the heating load and check the manufacturer's capacity table at your design temperature.
- Where the head goes matters as much as its size. High on an interior wall with a clear path across the room; never above a door where the airflow hits a wall, and never where furniture blocks the return. A correctly sized head in the wrong place performs like an undersized one.
24,000 BTU for a 700 ft² bonus room
The calculated load is 18,200 BTU, or 26 BTU per square foot once the room type is accounted for.
One room, one head, nowhere to hide a mistake
Central air averages a sizing error across the whole house. A mini-split does not — the head serves this room and only this room, so whatever you get wrong stays wrong in here.
That cuts both ways. It is why mini-splits are so good at fixing the one room that never worked, and why an oversized head is so noticeable: short cycles, no moisture removal, and a room that reads the right temperature on the thermostat and feels wrong to sit in.
Inverter heads are forgiving, up to a point
Unlike single-stage equipment, an inverter head throttles down rather than cycling off. That is genuinely why mini-splits tolerate imperfect sizing better than a central system.
What they cannot do is run below their minimum output. An oversized head spends the entire season sitting on that floor, and that is where the humidity complaints come from — not from the peak capacity, which it never uses.
Heating is a different number
A head rated 24,000 BTU for cooling does not deliver 24,000 BTU of heat when it is 5°F outside. Output falls as the outdoor temperature drops, and how steeply depends on the specific model — cold-climate units hold capacity far better than standard ones.
In a heating-dominated climate, size on the heating load and read the manufacturer's capacity table at your design temperature. The cooling rating is the wrong number to buy on.
Where it goes matters as much as its size
High on an interior wall, with a clear path across the room. Not above a door where the airflow immediately meets a wall. Not where a wardrobe or a curtain blocks the return.
A correctly sized head in a bad position performs like an undersized one, and it is the single most common installation fault.
Nearby sizes
- What size mini split for a 600 square foot bonus room
- What size mini split for a 800 square foot bonus room
- What size mini split for a 500 square foot bonus room
- What size mini split for a 1000 square foot bonus room
- What size mini split for a 700 square foot garage
- What size mini split for a 700 square foot sunroom
Read more
- Mini Split Blowing Cold Air in Heat Mode — Defrost, UsuallyEvery air-source heat pump does this. Knowing what a defrost cycle looks like is the difference between waiting ten minutes and calling somebody out.
- Mini Split Leaking Water Indoors — Four Causes, One CommonA cooling head makes a couple of litres a day. It leaves through a small pipe with no pump behind it, and that pipe is where nearly every leak starts.
- Multi-Zone Mini Split Not Cooling Every Room — The Minimum Output ProblemThe system is not underpowered. It is oversized for the one room that is calling, and multi-zone units handle that far worse than single-zone ones.