What size mini split does a 600 sq ft living room in Tacoma, WA need?
600 ft² living room in Tacoma, WA
9,000BTU/hr
7,799 BTU/hr of load at 11.8 BTU/ft² — the figure for 208 cooling degree days
| Head size to buy | 9,000BTU/hr |
|---|---|
| Calculated load600 ft² × 11.8 BTU/ft² × 1.1 for a living room | 7,799BTU/hr |
| BTU per square foot hereinterpolated from Tacoma's 208 cooling degree days | 11.8BTU/ft² |
| What the 20 BTU/ft² rule givesthe rule overshoots by 41% here | 13,200BTU/hr |
| Summer design temperature | 86°F |
| Winter design temperaturea mini split heats too — this is the number that decides whether it can carry the room alone | 19°F |
| Summer day–night swinga fairly dry climate | 24°F |
| Days at or above 90°F | 6days/yr |
| Oversize from the size stepwithin the normal step | 15% |
Notes
- The "20 BTU per square foot" rule is a Midwest number. Tacoma runs 208 cooling degree days, which works out to 11.8 BTU/ft² — so for this living room the rule overshoots by 41%. A single national figure has to be wrong somewhere, and this is where.
- Living room: more people, more glazing, more electronics. The 1.1× factor accounts for that.
- 9,000 BTU/hr sits close to the load, which is where a mini split works best. Inverter equipment is happiest running long and slow at part load; it is the short, hard cycles of an oversized head that leave a room cold and damp.
- Tacoma is dry — nights fall 24°F below the afternoon high, which only happens when there is little water in the air. Latent load is small, so nearly all of the head's capacity goes into temperature. A slightly undersized head is forgiving here: it simply runs longer.
- Do not forget the winter side. Tacoma designs to 19°F. A cold-climate rated head will hold most of its capacity there, but a standard one will not — ask for the capacity at 19°F in writing.
- Where these numbers come from. Tacoma / McChord Air Force Base, 12 km from downtown Tacoma, daily records 2015–2024. Design temperatures are calibrated against published ASHRAE values at eight airports and land within about 2°F of them.
The short answer
A 600 square foot living room in Tacoma, WA needs a head of about 9,000 BTU per hour. The calculated load is 7,799 BTU/hr.
Where that number comes from
Tacoma, WA runs 208 cooling degree days a year, which puts the room at 11.8 BTU per square foot rather than the 20 BTU/ft² the generic charts use. Applied to this room the rule gives 13,200 BTU/hr.
The winter half of the question
Tacoma, WA designs to 19°F. A mini split is a heat pump, and its heating capacity falls as the outdoor temperature drops — the nameplate is measured at 47°F, not at the temperature you actually need it.
Sizing a single room is not sizing a house
There is no other room to absorb a mistake. An oversized head short-cycles, never runs long enough to dehumidify, and leaves the room cold and damp.
Nearby sizes
- What size mini split does a 600 sq ft living room in Paradise, NV need?
- What size mini split does a 600 sq ft living room in Jamaica, NY need?
- What size mini split does a 600 sq ft living room in Richmond, VA need?
- What size mini split does a 600 sq ft living room in Salt Lake City, UT need?
- What size mini split does a 500 sq ft living room in Tacoma, WA need?
- What size mini split does a 800 sq ft living room in Tacoma, WA need?
- What size mini split does a 600 sq ft bedroom in Tacoma, WA need?
Read more
- Mini Split Blowing Cold Air in Heat Mode — Defrost, UsuallyEvery air-source heat pump does this. Knowing what a defrost cycle looks like is the difference between waiting ten minutes and calling somebody out.
- Mini Split Leaking Water Indoors — Four Causes, One CommonA cooling head makes a couple of litres a day. It leaves through a small pipe with no pump behind it, and that pipe is where nearly every leak starts.
- Multi-Zone Mini Split Not Cooling Every Room — The Minimum Output ProblemThe system is not underpowered. It is oversized for the one room that is calling, and multi-zone units handle that far worse than single-zone ones.