ZoneBtuBTU per head, per room, per orientation — not one number for the house.

What size mini split does a 400 sq ft living room in Millcreek, UT need?

400 ft² living room in Millcreek, UT
12,000BTU/hr
10,074 BTU/hr of load at 22.9 BTU/ft² — the figure for 1,631 cooling degree days
400 ft² living room in Millcreek, UT12,000 BTU/hrHead size to buy10,074 BTU/hrCalculated load8,800 BTU/hrWhat the 20 BTU/f…
Head size to buy12,000BTU/hr
Calculated load400 ft² × 22.9 BTU/ft² × 1.1 for a living room10,074BTU/hr
BTU per square foot hereinterpolated from Millcreek's 1,631 cooling degree days22.9BTU/ft²
What the 20 BTU/ft² rule givesthis room needs 14% more than the rule says8,800BTU/hr
Summer design temperature100°F
Winter design temperaturea mini split heats too — this is the number that decides whether it can carry the room alone13°F
Summer day–night swinga dry climate25°F
Days at or above 90°F67days/yr
Oversize from the size stepwithin the normal step19%

Notes

  • The "20 BTU per square foot" rule is a Midwest number. Millcreek runs 1,631 cooling degree days, which works out to 22.9 BTU/ft² — so for this living room the rule is 14% short. A single national figure has to be wrong somewhere, and this is where.
  • Living room: more people, more glazing, more electronics. The 1.1× factor accounts for that.
  • 12,000 BTU/hr sits close to the load, which is where a mini split works best. Inverter equipment is happiest running long and slow at part load; it is the short, hard cycles of an oversized head that leave a room cold and damp.
  • Millcreek is dry — nights fall 25°F below the afternoon high, which only happens when there is little water in the air. Latent load is small, so nearly all of the head's capacity goes into temperature. A slightly undersized head is forgiving here: it simply runs longer.
  • Do not forget the winter side. Millcreek designs to 13°F. A cold-climate rated head will hold most of its capacity there, but a standard one will not — ask for the capacity at 13°F in writing.
  • Where these numbers come from. Salt Lake City International Airport, 13 km from downtown Millcreek, daily records 2015–2024. Design temperatures are calibrated against published ASHRAE values at eight airports and land within about 2°F of them.

The short answer

A 400 square foot living room in Millcreek, UT needs a head of about 12,000 BTU per hour. The calculated load is 10,074 BTU/hr.

Where that number comes from

Millcreek, UT runs 1,631 cooling degree days a year, which puts the room at 22.9 BTU per square foot rather than the 20 BTU/ft² the generic charts use. Applied to this room the rule gives 8,800 BTU/hr.

The winter half of the question

Millcreek, UT designs to 13°F. A mini split is a heat pump, and its heating capacity falls as the outdoor temperature drops — the nameplate is measured at 47°F, not at the temperature you actually need it.

Sizing a single room is not sizing a house

There is no other room to absorb a mistake. An oversized head short-cycles, never runs long enough to dehumidify, and leaves the room cold and damp.

Nearby sizes

Read more