What size mini split does a 400 sq ft bedroom in Hobbs, NM need?
400 ft² bedroom in Hobbs, NM
12,000BTU/hr
10,303 BTU/hr of load at 25.8 BTU/ft² — the figure for 2,777 cooling degree days
| Head size to buy | 12,000BTU/hr |
|---|---|
| Calculated load400 ft² × 25.8 BTU/ft² | 10,303BTU/hr |
| BTU per square foot hereinterpolated from Hobbs's 2,777 cooling degree days | 25.8BTU/ft² |
| What the 20 BTU/ft² rule givesthis room needs 29% more than the rule says | 8,000BTU/hr |
| Summer design temperature | 103°F |
| Winter design temperaturea mini split heats too — this is the number that decides whether it can carry the room alone | 19°F |
| Summer day–night swinga dry climate | 25°F |
| Days at or above 90°F | 113days/yr |
| Oversize from the size stepwithin the normal step | 16% |
Notes
- The "20 BTU per square foot" rule is a Midwest number. Hobbs runs 2,777 cooling degree days, which works out to 25.8 BTU/ft² — so for this bedroom the rule is 29% short. A single national figure has to be wrong somewhere, and this is where.
- Bedroom: the room where oversizing hurts most — quiet, low load, long runtimes wanted.
- 12,000 BTU/hr sits close to the load, which is where a mini split works best. Inverter equipment is happiest running long and slow at part load; it is the short, hard cycles of an oversized head that leave a room cold and damp.
- Hobbs is dry — nights fall 25°F below the afternoon high, which only happens when there is little water in the air. Latent load is small, so nearly all of the head's capacity goes into temperature. A slightly undersized head is forgiving here: it simply runs longer.
- Do not forget the winter side. Hobbs designs to 19°F. A cold-climate rated head will hold most of its capacity there, but a standard one will not — ask for the capacity at 19°F in writing.
- Where these numbers come from. Midland International Airport, 123 km from downtown Hobbs, daily records 2015–2024. Design temperatures are calibrated against published ASHRAE values at eight airports and land within about 2°F of them.
The short answer
A 400 square foot bedroom in Hobbs, NM needs a head of about 12,000 BTU per hour. The calculated load is 10,303 BTU/hr.
Where that number comes from
Hobbs, NM runs 2,777 cooling degree days a year, which puts the room at 25.8 BTU per square foot rather than the 20 BTU/ft² the generic charts use. Applied to this room the rule gives 8,000 BTU/hr.
The winter half of the question
Hobbs, NM designs to 19°F. A mini split is a heat pump, and its heating capacity falls as the outdoor temperature drops — the nameplate is measured at 47°F, not at the temperature you actually need it.
Sizing a single room is not sizing a house
There is no other room to absorb a mistake. An oversized head short-cycles, never runs long enough to dehumidify, and leaves the room cold and damp.
Nearby sizes
- What size mini split does a 400 sq ft bedroom in Muskogee, OK need?
- What size mini split does a 400 sq ft bedroom in Florence, SC need?
- What size mini split does a 400 sq ft bedroom in Whitney, NV need?
- What size mini split does a 400 sq ft bedroom in Waipahu, HI need?
- What size mini split does a 300 sq ft bedroom in Hobbs, NM need?
- What size mini split does a 500 sq ft bedroom in Hobbs, NM need?
- What size mini split does a 400 sq ft living room in Hobbs, NM need?
Read more
- Mini Split Blowing Cold Air in Heat Mode — Defrost, UsuallyEvery air-source heat pump does this. Knowing what a defrost cycle looks like is the difference between waiting ten minutes and calling somebody out.
- Mini Split Leaking Water Indoors — Four Causes, One CommonA cooling head makes a couple of litres a day. It leaves through a small pipe with no pump behind it, and that pipe is where nearly every leak starts.
- Multi-Zone Mini Split Not Cooling Every Room — The Minimum Output ProblemThe system is not underpowered. It is oversized for the one room that is calling, and multi-zone units handle that far worse than single-zone ones.