ZoneBtuBTU per head, per room, per orientation — not one number for the house.

What size mini split does a 300 sq ft living room in Reno, NV need?

300 ft² living room in Reno, NV
9,000BTU/hr
7,039 BTU/hr of load at 21.3 BTU/ft² — the figure for 1,219 cooling degree days
300 ft² living room in Reno, NV9,000 BTU/hrHead size to buy7,039 BTU/hrCalculated load6,600 BTU/hrWhat the 20 BTU/f…
Head size to buy9,000BTU/hr
Calculated load300 ft² × 21.3 BTU/ft² × 1.1 for a living room7,039BTU/hr
BTU per square foot hereinterpolated from Reno's 1,219 cooling degree days21.3BTU/ft²
What the 20 BTU/ft² rule givesthis room needs 7% more than the rule says6,600BTU/hr
Summer design temperature99°F
Winter design temperaturea mini split heats too — this is the number that decides whether it can carry the room alone16°F
Summer day–night swinga dry climate32°F
Days at or above 90°F72days/yr
Oversize from the size stepa big step — read the note28%

Notes

  • The "20 BTU per square foot" rule is a Midwest number. Reno runs 1,219 cooling degree days, which works out to 21.3 BTU/ft² — so for this living room the rule is 7% short. A single national figure has to be wrong somewhere, and this is where.
  • Living room: more people, more glazing, more electronics. The 1.1× factor accounts for that.
  • 9,000 BTU/hr is 28% above the load, and the gap between head sizes is wide — the next size down is 6,000. In a single room that matters more than it would on a central system: there are no other rooms to absorb the excess capacity. If the room is well insulated and shaded, the smaller head is usually the better buy, and modern inverter compressors modulate down far better than they modulate up.
  • Reno is dry — nights fall 32°F below the afternoon high, which only happens when there is little water in the air. Latent load is small, so nearly all of the head's capacity goes into temperature. A slightly undersized head is forgiving here: it simply runs longer.
  • Do not forget the winter side. Reno designs to 16°F. A cold-climate rated head will hold most of its capacity there, but a standard one will not — ask for the capacity at 16°F in writing.
  • Where these numbers come from. Reno/Tahoe International Airport, 7 km from downtown Reno, daily records 2015–2024. Design temperatures are calibrated against published ASHRAE values at eight airports and land within about 2°F of them.

The short answer

A 300 square foot living room in Reno, NV needs a head of about 9,000 BTU per hour. The calculated load is 7,039 BTU/hr.

Where that number comes from

Reno, NV runs 1,219 cooling degree days a year, which puts the room at 21.3 BTU per square foot rather than the 20 BTU/ft² the generic charts use. Applied to this room the rule gives 6,600 BTU/hr.

The winter half of the question

Reno, NV designs to 16°F. A mini split is a heat pump, and its heating capacity falls as the outdoor temperature drops — the nameplate is measured at 47°F, not at the temperature you actually need it.

Sizing a single room is not sizing a house

There is no other room to absorb a mistake. An oversized head short-cycles, never runs long enough to dehumidify, and leaves the room cold and damp.

Nearby sizes

Read more